Science Fair Project Encyclopedia
- Below is an article about the physical phenomenon of wave interference.
- Other possible meanings of interference:
Interference, also called "plasma (pattern)", is the superposition (overlapping) of two or more waves resulting in a new wave pattern. As most commonly used, the term usually refers to the interference of waves of the same or nearly the same frequency.
The principle of superposition of waves states that the resultant displacement at a point is equal to the sum of the displacements of different waves at that point. If a crest of a wave meets a crest of another wave at the same point then the crests interfere constructively and the resultant wave amplitude is greater. If a crest of a wave meets a trough then they interfere destructively, and the overall amplitude is decreased.
Interference is involved in Thomas Young's double-slit experiment where coherent light (light which is in the same phase, and has the same frequency and wavelength) interferes to produce an interference pattern. More generally, this form of interference can occur whenever a wave can propagate from a source to a destination by two or more paths of different length. Two or more sources can only be used to produce interference when there is a fixed phase relation between them, but in this case the interference generated is the same as with a single source; see Huygens' principle. When a single source interferes with itself, the principle of conservation of energy dictates that the energy "missing" from the darkened regions of an interference pattern where destructive interference has taken place will be found in the brightened portions where constructive interference has taken place.
Light from any source can be used to obtain interference patterns, for example, Newton's rings can be produced with sunlight. However, in general white light is less suited for producing clear interference patterns, as it is a mix of a full spectrum of colours, that each have different spacing of the interference fringes. Sodium light is close to monochromatic and is thus more suitable for producing interference patterns. Most suitable is laser light because that is almost perfectly monochromatic.
Constructive and destructive interference
When two waves superimpose, the resulting waveform depends on the frequency, (or wavelength) amplitude and relative phase of the two waves. If the two waves have the same amplitude A and wavelength the resultant waveform will have amplitude between 0 and 2A depending on whether the two waves are in phase or out of phase.
| ||Two waves in phase|| Two waves 180° out |
Consider two waves that are in phase,with amplitudes A1 and A2. Their troughs and peaks line up and the resultant wave will have amplitude A = A1 + A2. This is known as constructive interference.
If the two wave's are 180° out of phase, then one waves hump will coincide with another wave's trough and so will tend to cancel out. The resultant amplitude is A = |A1 − A2|. If A1 = A2 the resultant amplitude will be zero. This is known as destructive interference.
The contents of this article is licensed from www.wikipedia.org under the GNU Free Documentation License. Click here to see the transparent copy and copyright details