Science Fair Project Encyclopedia
A center punch is typically used as an aid to drilling operations; a drill, when brought into contact with a flat surface, will have a tencancy to wander on the surface until it gains sufficient purchase to start cutting a hole. A center punch forms a small hole in which the tip of the drill (if it is small enough) will fit. When drilling larger holes where the web of the drill is wider than the indentation produced by a center punch, the drilling of a pilot hole is usually needed. A center punch usually has a tip, that when viewed on a profile, has sides at a 90 degree angle to one another.
A prick punch, while easily confused with the similar looking center punch, serves an entirely different purpose. A prick punch is primaly used for the purposes of layout. By design it produces a smaller indentation than a center punch, which acts as a useful datum point in layout operations. When layout is complete, the indentation made with a prick punch can be enlarged with a center punch to allow for drilling. A prick punch usually has a tip, that when viewed on a profile, has sides at a 30-60 degree angle to one another.
The purpose served by pin punches is somewhat different than the center or prick punches. A pin punch is used as a driving tool, typically, as the name implies, to drive pins that are used to affix a fixture to a rotating shaft. Pin punches are typically characterized by a hexagonal body, with a long, flat ended cylindrical section.
A doming punch is used in conjunction with a doming block to make spheres or hemispheres out of sheets of metal. The punch is generally made of tool steel, but can be made of wood. They come in a number of different sizes, the punch size determining what size the finished product will be.
A drift "punch" is misleadingly named; it is not used as a punch in the traditional sense of the term. A drift punch, or drift pin, is used as an aid in aligning bolt or rivet holes prior to inserting a fastener. A drift punch is constructed as a tapered rod, with the hammer acting on the large end of the taper. The tapered end of a drift punch is placed into the semi-aligned bolt holes of two separate components, and then driven into the hole. As it is driven in, the taper forces the two components into alignment, allowing for easy insertion of the fastener. Unlike most punches, force is never (and should never be) applied to the tip, or end of a drift pin.
Also known as Letter or Number stamps.
These are used to emboss the impression of a letter or number into a workpiece. They are most common in the reverse image, this allows the end result to be immediately readable, however they may be made as a positive image. This is essential in the case of die or mold making and ensures that the finished product will in fact be readable, a die is in fact a negative image already.
The contents of this article is licensed from www.wikipedia.org under the GNU Free Documentation License. Click here to see the transparent copy and copyright details